Introduction

Use this guide to replace your motherboard for your Auking M8-F projector.

The motherboard is responsible for all the components of your projector to communicate with each other. A faulty motherboard can affect the projector's overall performance, causing the whole projector to not work to the best of its capability. In some cases, an old or damaged motherboard can cause the projector to not function properly.

If you are experiencing issues with the function of the projector, please take a look at the troubleshooting page to see if the problem can come from other causes. If none of these solutions seems to be enough, then the motherboard may be the issue.

Before continuing this guide, be sure to turn off your projector completely.

  1. CBsDhfycutV1VHPo
    CBsDhfycutV1VHPo
    EFOh2Na52LaNyiVQ
    • Make sure that the device is unplugged from any power source before attempting any repairs.

    • Flip the projector on its opposite side.

    • Remove all six of the 11 mm screws on the base of the projector using a Phillips #1 screwdriver.

    • Remove the two 14 mm screws using a Phillips #1 screwdriver.

  2. pAnRqNhsOX4HSqPI
    pAnRqNhsOX4HSqPI
    15ywIlWMAshRpqCu
    GkZultZJG4UKvhqL
    • Carefully prop open the top of the projector.

    • To remove the cord that is attached to the top, carefully wiggle the cord out.

    • Remove the top lid.

  3. AMaYvKXlJl2B15Th
    AMaYvKXlJl2B15Th
    yNnQyZxcknyLeUcE
    oOQOitCXuGKj4aZd
    • Flip up the black locking flaps then remove the two ribbon cables.

  4. CjOicRXPIAZACnBO
    CjOicRXPIAZACnBO
    RL5qZuLeXfwCvTMO
    • Remove the two 9 mm screws using the Phillips #00 screwdriver.

  5. BwaqWU11HIDCaKKw
    BwaqWU11HIDCaKKw
    QHnUcoLGYLmLoXyq
    • Carefully disconnect the wires that are attached to the motherboard.

    • Remove the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jennifer Vazquez

Member since: 13/09/23

121 Reputation

0 comments