DJI Phantom 4 Advanced Remote Controller Back Panel Replacement

Written By: cade knott
  • Comments: 0
DJI Phantom 4 Advanced Remote Controller Back Panel Replacement

Difficulty

Moderate

Steps

5

Time Required

5 minutes

Introduction

Use this guide to replace the back con board of a DJI Phantom 4 Advanced Remote Controller.

With step by step detailed instructions, you will be able to safely resolve issues that may arise with the back con board.

  1. PRIaEWyH5PGGmJGx

    • Remove the four screws with a Torx T8 screwdriver to access the back con board.

  2. wUXTmD6wcLRfKhwn
    wUXTmD6wcLRfKhwn
    fRx2XTAJbRentMZA

    • Remove three screws using a Phillips #00 screwdriver.

  3. DDU6dYsQn4olEbKY
    DDU6dYsQn4olEbKY
    sgt6doy1gH2krkXs

    • With tweezers, gently remove the large con board tab.

    • Use your hands to remove the two small clips. Pull out from the socket, in a horizontal direction.

  4. jPdVUPpUHqrc4UBi
    jPdVUPpUHqrc4UBi
    vVA1t23yQTPafj4e

    • Peel off the rubber grips to access the screw holes.

    • Make sure to save your grips and do not to get them stuck to anything, you are going to want to save the adhesive.

    • Remove the back board and set it aside.

  5. YIrIaqne3wkgbLtK
    YIrIaqne3wkgbLtK
    XCXtaGNaFySJWTcM

    • Pull apart the back plastic panel.

    • Recommended tool for this would be the metal spudger, but not required.

    • Once the back panel is off, you will have access to the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

cade knott

Member since: 02/10/18

481 Reputation

0 comments