Dell AC511 Hanger Replacement

Written By: William Cook
  • Comments: 0
Dell AC511 Hanger Replacement

Difficulty

Moderate

Steps

4

Time Required

1 - 2 minutes

Introduction

If your device does not properly hang to the bottom of compatible Dell monitors, you may need to replace one or both of its hangers.

  1. CwRuTRP2HsWHeWlF
    CwRuTRP2HsWHeWlF
    tO4IqVWiBnasUj2T
    FNTjumEdRL1hP4B3

    • Use a Jimmy to peel off the screen stuck to the front of the speaker.

    • Start from any corner and use the Jimmy to get under the screen. Once one side lifts up, you can use your fingers to peel the rest off.

    • Be careful to avoid damage to the rest of the speaker and especially to yourself.

    • Don't worry if it tears; use the Jimmy again to peel off the rest.

  2. equylohcLKbYZCJm
    equylohcLKbYZCJm
    4vcaFVlkvHvpqYAc

    • Remove ten 6 mm screws using a Phillips #1 screwdriver.

  3. qcZ6fDPgmXcLvuWV
    qcZ6fDPgmXcLvuWV
    QDVZMgaBX4XOuEOu

    • Lift the front panel off of the rest of the device.

    • The speakers will still be attached to the front panel. Being too rough could damage them.

    • Remove the 4 mm screws from the speakers using a JIS #1 screwdriver.

    • Remove the front panel from the device.

  4. PqTwADvdwBDNptTy
    PqTwADvdwBDNptTy
    WInSUDmJwM4XOXgp

    • The speakers do not have to have been removed for this step, though it may make it easier.

    • Remove the screws from the hangers you are looking to replace using a JIS #1 screwdriver.

    • We accidentally removed some of the rubber lining the inside along with the hanger. Use a razor to cut it off before removing the hanger.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

William Cook

Member since: 19/03/24

617 Reputation

0 comments