Introduction
Follow this guide if you need to remove the back case of your EasySMX ESM-9100 controller to access the internal components.
-
-
Place the controller face down on a solid surface.
-
Use a Phillips #00 screwdriver to remove the seven 10 mm screws from the back cover.
-
-
-
Use the iFixit opening tool to pry off the back cover and remove it to reveal the internal components.
-
Place the cover off to the side, then grab the circuit board and gently remove it from the front cover.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
