Jabra Elite 85h Microphone Replacement

Written By: Ryan Callaghan
  • Comments: 5
Jabra Elite 85h Microphone Replacement

Difficulty

Moderate

Steps

8

Time Required

No estimate

Introduction

  1. QVOnAI6Th1tUpOWC
    QVOnAI6Th1tUpOWC
    S5T3TTIaLsOa3hTv
    LeDtQRnBKONgQGHB

    • Remove each ear cushion by hooking your fingers along the inside of the ear cushion and pulling up and away from the ear cup.

    • If the cushion does not fully release, move your hand to the opposite side and pull up inn the same manner.

    Hi sir, I think your guide is incomplete. Do you have the opportunity to bring a sequel?

    Oğuzhan Sancak -

    The battery is under the left earcup.

    NOT the earcup into which you plug the USB cable.

    Not sure why the demo asks you to disassemble the right earcup...

    Jimbo -

    These instructions could use some work! There is no need to disassemble both sides as the battery is under the left ear cup only.

    kelly1 -

    I have just disassembled mine, Jabra Elite 85h, model OTE100. The cushions (as described in this step) can not be removed. If that's the case, The foam in the center has to be removed to access the speaker screws. Undoing the screws will split the headphone in half, releasing the pad together with the speaker. This will uncover the rest of the components

    Besides, I agree with the rest of the comments - If you're after the battery there is no need to disassemble the right headphone as the battery resides in the left

    bystrzak14 -

  2. MOSSox6BGbM5ZQFN
    MOSSox6BGbM5ZQFN
    SLQCZDbxtCPmFtJT
    ZDDeK4deyGILEOFK

    • The foam inserts and backing tape are very delicate. Take your time when removing them, and be careful to not rip or tear the material.

    • Using the small plastic spudger to assist, begin lifting up and removing the foam inserts with attached backing tape.

  3. HV1i5TsUTIQMMeTo
    HV1i5TsUTIQMMeTo
    eIrhHuOApTKbIRvp
    GJ4OH2eyn3xRSoIP

    • Repeat the previous steps for the other side, removing the foam inserts with care.

  4. Olkaoy4RCCYbMcVw

    • Unscrew and remove the four T6 screws holding the speaker in place.

  5. glKFtkWgwLaOTTDH

    • Repeat the previous step for the other side, removing the four T6 screws.

  6. CFmZL4vkObKq1Qm6

    • Tilt the headphones over so that the speaker tilts out of the plastic holder.

    • Repeat for both sides.

    Battery is behind left speaker ONLY.

    Đorđe Radomirović -

  7. RgiJCBCucryvZfgc
    RgiJCBCucryvZfgc
    bLYNEfhJwKrYEiU5

    • Remove the four screws attaching the circuit boards to the headphone enclosure.

    • The microphone is located on the lower circuit board.

  8. KODnGjW4p24UKviT
    KODnGjW4p24UKviT
    HaxvKao2G5HFLPWw
    iSBcrwEcGUTTnjlK

    • Remove the circuit boards from the headphone enclosure.

    • Carefully lift the bar located on the lower circuit board that contains the 24-pin ribbon cable. Remove the cable.

Conclusion

If the microphone on your Jabra Elite 85h is not working, replacement could be an appropriate solution.

Author

Ryan Callaghan

Member since: 13/03/23

693 Reputation

0 comments