Introduction
The official guide has been updated and can be found here.
This guide will explain how to replace the back panel on the Lenovo ThinkPad X1 Carbon 7th Gen.
Oftentimes, the back panel does not need to be replaced unless the laptop was physically damaged from things like dropping it. However, knowledge of how to remove the back panel is important to accessing the rest of the device’s components.
Before trying to access the back panel, make sure the computer is shut down and is unplugged from any external power sources.
-
-
Restart the computer. When the Lenovo logo is displayed, immediately press enter, then press F1 to enter the BIOS Setup Utility
-
Use the arrow keys to select Config→Power.
-
Select "Disable Built-in Battery".
-
The battery will be re-enabled when the charger is connected.
-
-
-
Flip the laptop over on a flat surface with the back panel facing up.
-
Remove the five 5 mm Phillips #0 screws from the edge of the back panel.
-
Insert an opening tool between the back panel and edge. Maneuver the tool around the panel, disconnecting the clips holding the panel in place.
-
To reassemble your device, follow these instructions in reverse order.
