Nintendo WaveBird Wireless Controller Front Panel Replacement

Written By: JT Gryder
  • Comments: 0
Nintendo WaveBird Wireless Controller Front Panel Replacement

Difficulty

Easy

Steps

4

Time Required

5 - 10 minutes

Introduction

This guide will help you remove the front panel of the controller. It is a prerequisite guide only.

  1. gIc3eroIeGlIjSQ2
    gIc3eroIeGlIjSQ2
    kB3lriVOXO6M2WJ5

    • Pull down on the battery cover release lever and pull back to remove the cover.

  2. ihC1vNSuSNCMJlKO

    • Remove both batteries from the device.

  3. BQJIvRpASkXSABSU
    BQJIvRpASkXSABSU
    1KiSGhUGXcCNBbT4

    • Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver.

    • During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.

  4. ivsa5goaQNZepGLO
    ivsa5goaQNZepGLO
    RHjvYmMuCMeWQGnh

    • Carefully turn over the controller and place it on a flat surface.

    • Slowly separate the top panel from the bottom panel.

    • The buttons are loose and may fall off the motherboard.

    • Once separated, set aside the top panel.

    • During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

JT Gryder

Member since: 12/04/13

105 Reputation

0 comments