Nintendo Wii Remote Main Buttons Replacement

Written By: Emily
  • Comments: 7
Nintendo Wii Remote Main Buttons Replacement

Difficulty

Moderate

Steps

6

Time Required

5 - 10 minutes

Introduction

Removing the main buttons requires opening the device. The main buttons include all buttons except the trigger style B button.

  1. CJPWTUaLIJOrlTjL
    CJPWTUaLIJOrlTjL
    IKLUxxGL3i16PRVa

    • Flip the Wii Remote over so the battery cover faces you.

    • Push up on the bottom tab.

    • Remove the battery cover.

    my battery cover is different. The batteries are attached to the actual cover and come out when the back is removed.

    Kim Pearson -

  2. SpfsueKLnC6dearn

    • Remove the first battery by pressing down on the positive end and pulling the battery out.

    • Remove the second battery by pushing up on the positive end and pulling the battery out.

  3. KRhx6OCSHj1kHfvi

    • Using a tri-point Y1 Screwdriver, remove the two center 7mm screws by turning them counterclockwise.

    • Repeat with the two bottom screws.

  4. I6UxdQOmurieZqPI
    I6UxdQOmurieZqPI
    PgoiMal1wGhU3rSa

    • With the flat end of a spudger, gently apply pressure to the tabs located on left side of the controller.

    • These tabs are breakable. However, if the tabs are broken the controller will still function.

    • Open the front plate like a book.

    • Small parts may fall out as you open the front plate.

    Mine is not opening like a book? What do I do?

    Micah Thompson -

    It stops short of explaining replacing rechargeable battery. Unless you’re referring to the AA’s which don’t involve removing cover

    Sticky Insides -

  5. rwSLbGn2VJJcNFo3
    rwSLbGn2VJJcNFo3
    wTgdZlqTeUiDwOKI

    • Working on the inside of the front cover, peel off the three rubber pads covering the buttons.

  6. UIABusoHwWVBPjut

    • Flip over the cover, allowing the buttons to fall into your hand.

    • Be ready to catch all the buttons, some are very small. If a button does not fall out apply gentle pressure from behind.

    • When reassembling, put each plastic button in its allocated slot. Each button only fits snugly in one slot.

    • The best option for you is rotate the Wii Controller by 180°. If you obey this note, the small parts wont fall off and then you can remove the buttons.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Emily

Member since: 14/04/13

1593 Reputation

4 comments

Where did you get your replacement buttons? I can't find them online anywhere...

devannedloss -

Me too, can’t find them.

Michael Velten -

2024 and can't find them online ANYWHERE! I'm hoping a WiiUDpad fits on the wiimote. You'd think there'd be a bunch of wiimote shells of different colours available everywhere online, but they're nowhere to be found

how frustrating!

MartianIsotopes -

Vinted is full of them. Although some people ask wayyy too much for them!

Sophie Nicholson -