PDP Rematch Joystick Replacement

Written By: Amina Begum
  • Comments: 0
PDP Rematch Joystick Replacement

Difficulty

Easy

Steps

5

Time Required

5 minutes

Introduction

The Joystick is an essential part of the PDP Rematch controller. Over time, the joysticks may stop working due to wear and tear. If they need replacing, you can buy them separately.

  1. MCwQTytdBhoLkgMX
    MCwQTytdBhoLkgMX
    RGNdCmNyQ1JUdVgY

    • Grip one side of the controller firmly.

    • Insert an opening pick into the crease between the faceplate and the body of the controller.

    • Once the pick creates a gap in the crease, gently insert another pick into a different section of the crease.

    • Carefully move the picks along the controller's crease line until you hear a popping sound.

    • Gently lift off the faceplate by hand.

  2. GNd2HBdtZJfpXqRr
    GNd2HBdtZJfpXqRr
    C6Go4oQSl3oXuKS6

    • Remove the 8 mm screws from the hard cover using a JIS #00 screwdriver.

    • Since the screws have been removed, avoid shaking or moving your controller too much to prevent other buttons from falling out.

  3. SWqMuZWv1kF3m4Q1
    SWqMuZWv1kF3m4Q1
    rePcYyIVSbViwIcq

    • Gently lift off the hard cover with your hand; it should not need much force.

  4. CRcCkSuGT1UDH2iC

    • The action buttons and silicone pad are loose and may fall out of the controller.

  5. oY5wdE2AuhAbRiA1
    oY5wdE2AuhAbRiA1
    deaJmwWCkIR4AN4M

    • Gently rotate or twist the joystick(s) you want to replace.

    • Apply some force and pull upward towards you.

    • You will know it is released when you hear a popping sound.

    • Place your new joystick and push it downwards; you will hear a popping sound again.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Amina Begum

Member since: 16/01/24

282 Reputation

0 comments