Introduction
A brief description on how to remove the logic board
Tools
-
-
Heat the left and top edges with hairdryer for one minute.
-
Move hairdryer back and forth to evenly heat up surface.
-
-
-
Leave plastic opening tools in between front and back casing.
-
Rotate Palm and repeat steps 2 and 3 for right and back edges.
-
-
-
Now pry open front and back casing with plastic opening tools.
-
Separate front and back casing completely.
-
-
-
Now you must flip up the adjacent clamp as well, using tweezers like before.
-
After the clamp is flipped you can gently remove the second ribbon with tweezers.
-
-
-
Before removing the screen you must detach one more wire, the battery connector.
-
Using the tweezers, squeeze the connector attached to the wire and genlty pull.
-
-
-
Now that both ribbons and the wire are disconeccted, you can apply a downward pressure to the battery. You will have to carefully rotate the frame so that the battery can go through.
-
-
-
Lift up the black flap covering the ribbon cable with your hand
-
With the spudger, left green cable clamp
-
Gently remove ribbon cable from clamp
-
To reassemble your device, follow these instructions in reverse order.