Introduction

This process involves removing the back cover and the front cover of the Ricoh YF-20 Super camera.

  1. kmvAbqml51ipOqJw
    kmvAbqml51ipOqJw
    iQ5OQCj24nXQpFJL
    • Use the screwdriver to unscrew the indicated screws from the left, right, bottom, and back sides of the camera.

  2. BuDbOMhVomPAlDOp
    BuDbOMhVomPAlDOp
    Ujj5GfViVdUxUYKV
    nTQw2mWcOxtrP46C
    • Loosen the back cover from both the left and the right sides of the camera. Take off the back cover.

    • The lid of the battery compartment may fall off because it is not attached to anything.

  3. YcgvBsQ3nTOMuNvT
    YcgvBsQ3nTOMuNvT
    UMQSY2QaXIAvVvD4
    mwmSH1IUFjofQiEg
    • Open the film compartment.

    • Press your finger on top of the grey latch on the left side of the camera.

  4. C1MKCeTWTF3LFEMw
    C1MKCeTWTF3LFEMw
    ZROWOShk5sxIR6LQ
    lVJ32D5O2b3nIUS6
    • Removing the film compartment door is optional. However, it may aid maneuverability in future steps.

    • Use a thin object like a toothpick or a small screwdriver to push down on the metal pin holding the film compartment door in place.

    • Use your fingers to completely remove the metal pin.

    • Remove the film compartment door.

  5. TtpKKCKnRbTuKGY5
    TtpKKCKnRbTuKGY5
    K21bVLUBrmTI2xMY
    • Use a thin shaft screwdriver and unscrew the two indicated screws within the film compartment.

  6. wCUCPFSBylIg5UZa
    wCUCPFSBylIg5UZa
    rIOWgBCphWgsRtq5
    vMkmX3PVYkxESiDI
    • Loosen the front cover from the left and right sides of the camera.

    • Take off the front cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Eric Dazet

Member since: 10/04/12

352 Reputation

0 comments