Sony CPF-IP001 Subwoofer Housing Disassembly

Written By: Mike Bolton
  • Comments: 0
Sony CPF-IP001 Subwoofer Housing Disassembly

Difficulty

Easy

Steps

5

Time Required

15 - 20 minutes

Introduction

This guide shows you how to disassemble the subwoofer so you can access any interior parts for repair.

  1. sARDICgYhZfEex1s
    sARDICgYhZfEex1s
    x3MXQV4mRVOWga2u

    • Remove fourteen 8 mm Phillips #2 screws from the bottom of the subwoofer.

    • Once all of the screws are removed, the cover can be taken off using a metal spudger.

  2. IUFj3qgQTJtAXoBy
    IUFj3qgQTJtAXoBy
    ROGQSRbg3JuBG6WW

    • Remove eight 14 mm Phillips #2 screws holding the circuit board in place.

    • Using the plastic opening tool, carefully remove the circuit board.

    • There will be 3 wires connected to the opposite side of the circuit board. Be careful not to pull the board out of the device too far and damage these wires.

  3. ZG6JZbvK2IxWvsnA
    ZG6JZbvK2IxWvsnA
    DphmMGouWQmh4FUf

    • Remove the first of the three wires by squeezing the clip and pulling it out.

    • After disconnecting the first wire, the two attached wires can be more easily accessed.

  4. iQvGmSyLCONu1iT2
    iQvGmSyLCONu1iT2
    iMsHOLk4SSwZQLUl
    ueLyUwb5HvwkP1GF

    • Remove the wire furthest to the left by squeezing the clip and pulling it out.

    • Detach the third wire by carefully using the tweezers.

    • The circuit board is now completely detached and can be set aside.

  5. Q6DNAqidR4XCULQg
    Q6DNAqidR4XCULQg
    ychqtutQKdu3Uvc2

    • Remove six 8 mm Phillips #2 screws.

    • Slide the side panel with the power cord out from the housing.

    • The side panel with the power cord will come out as a whole unit with the subwoofer air tunnel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Mike Bolton

Member since: 14/04/15

473 Reputation

0 comments