Sublue WhiteShark Mix Underwater Scooter Activation Buttons Replacement

Written By: Benjamin J Farland
  • Comments: 0
Sublue WhiteShark Mix Underwater Scooter Activation Buttons Replacement

Difficulty

Moderate

Steps

12

Time Required

30 minutes

Introduction

This guide shows you how to replace the two activations buttons for the Sublue WhiteShark Mix Underwater Scooter.

  1. hWbKOQbDDG6lAbQR

    • Remove the black screw by rotating it counterclockwise.

  2. ffbrZuMbgCRFZifE

    • Hold the device in place and pull up on the floater.

  3. kcUfhRi26l2SlfIH

    • Remove the top floater.

  4. T3iMtnuPtqpYDSXx

    • Turn the device upside-down.

  5. JjJnH4djhLGEmILy

    • Press the push button in while sliding the planner towards the back of the device to remove the battery panel.

  6. lwBRGsyCfQlHUB1A

    • A push tab holds the battery in.

  7. ncKIGgLJ2AW55Dn1

    • Push the tab in and pull the battery outward to remove it.

  8. aNdtSFMyYvAWGdDK

    • Remove the ten Phillips screws on the bottom of the device. Remove the bottom panel.

  9. tisKUPZc4G2OCYNI

    • Pull the panel forward.

    • You may need to use pry tools to aid in separating the panels.

  10. V2W4FLjcUwaJO31W

    • There are two action buttons on each side of the main body.

  11. dy1ImrQvljFt3Ffs

    • Push on the top outer corner of each action button to pop them out of place.

  12. b4a3hAPNvk1hW1w5

    • After each action button is released, pull outward to remove.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Benjamin J Farland

Member since: 30/10/23

271 Reputation

0 comments