YCCTEAM YCC-SW4001 Front Case Replacement

Written By: David Adaway
  • Comments: 0
YCCTEAM YCC-SW4001 Front Case Replacement

Difficulty

Easy

Steps

7

Time Required

15 minutes

Introduction

If you need to replace any of the components within the YCCTEAM YCC-SW4001, you will need to remove the front cover first.

The front cover is an important part of the controller. It includes the ABXY buttons, shoulder buttons, and connects to the back cover via a ribbon cable. This component is often replaced or modified for cosmetic purposes.

Exercise caution when removing the ribbon cable, as there is a component that needs to be carefully moved and can easily be broken.

  1. ngdvO1ZITkwfT1R2

    • Use a Phillips #1 screwdriver to remove the eight 9.15 mm screws that secure the back case.

  2. 6tTL32ZcQEW1lDXR
    6tTL32ZcQEW1lDXR
    jERbIGopXQnXRfnJ
    LfSm3TgWyVSFIJgt

    • Use an opening pick to pry the back cover off of the controller.

    • This exposes the battery’s housing.

  3. Il2gdVMC5L1wHZsk

    • Use a Phillips #1 screwdriver to remove the three 9.15 mm screws from the back of the controller.

  4. nODc5iMbW3gCCqFM
    nODc5iMbW3gCCqFM
    1A5lNfOsdeR15ACA
    NyVsbNoueFmUlM4Y

    • Delicately lift the front case slightly by pulling it away from the back case.

    • Do not remove the front cover completely; it is still attached to the motherboard by a white ribbon cable.

  5. PtvsNhcDONldYhtf
    PtvsNhcDONldYhtf
    6EenHVPCcqYLui5I
    HX1CwAKd6HkVIqYv

    • Use the tip of the opening pick to flip up the black locking flap of the ZIF connector.

    • The black flap holds the white ribbon cable in place.

  6. usdRBfUwDZKPH6Jo
    usdRBfUwDZKPH6Jo
    NHKOphBIgYJLgLmk

    • Use tweezers to disconnect the white ribbon cable from the ZIF connector.

  7. LMoGY2poIJsYn6qa

    • Remove the front case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

David Adaway

Member since: 16/02/24

531 Reputation

0 comments