Introduction

One RAM slot will accept PC100 or PC133 chips up to 512 MB.

  1. SFNXXLIPAVtTfoBc
    • Use a coin to turn both battery locking screws 90 degrees to the left.

    • Remove the battery cover.

    • Remove the battery from the computer by pulling up on the plastic tab.

  2. TuAR6NdLjFJF2J1Z
    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free. Note that the keyboard ribbon is still attached to the logic board, so you cannot completely remove the keyboard yet.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (between F4 and F5 key) 180 degrees in either direction and try again.

    • Rotate the keyboard away from the screen and rest it face-down on the trackpad area.

  3. SIQqrMrKvDoiSMhV
    • If your computer does not have an airport card, you can skip the next two steps.

    • Grasp the clear plastic tab on the airport card and pull up and toward the display.

    Note to those who want to install an airport card to a laptop here that doesn't have a card. The proper orientation is with the bar code facing up, and the "Airport" artwork and logo facing down. There are small slots on the bottom of the card that fit into pins below the trackpad. You will know it is properly slotted because the top of the card will touch the handles of the RAM shield.

    The proper orientation of the antenna is that it is plugged in from the right side of the top of the airport card, with the cable winding up from the right to the left.

    Marissa Stardance -

  4. 2Y2lllKp2lFKaSNY
    • Hold the airport card in one hand and use your other hand to remove the antenna cable.

  5. 6RAaAVZHGeW3NNev
    • Remove the two Phillips screws that secure the RAM shield.

  6. Fe5LCpxRuUPtSnqK
    • Grasp the wire metal bracket on top of the RAM shield and pull upward to remove the shield.

  7. do5IHyWKVDowdd5J
    • Pull up the keyboard connector cable by its clear plastic loop.

  8. YjVOWFureXQ3ggXv
    • Your laptop should look approximately like this.

  9. URhNNypnFPwBMhZC
    • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

    • Pull the chip directly out from its connectors.

Conclusion

To reassemble your device, follow these instructions in reverse order.

iRobot

Member since: 25/09/09

0 Reputation

One comment

I love that iFixit will sell you a quarter ($0.25) for $2.99 plus tax and shipping, another $3.29 shipping (totally reasonable), and sales tax for my location - the total is $6.59. I wish I could sell quarters for $6.59. đŸ¤£

UnCoopervised -