1

I am not that much of a guru in fusionpbx. I have already set it up. I need to add a gateway from a provider that does not have a username and password. The provider only has an IP. My problem is that when i try to add the gateway i get an error message that i must put a username and a password. How to i go about adding the gateway?

Regards

william
  • 11
  • 1
  • 3

2 Answers2

1

The username and password are required by mod_sofia. You can however set the gateway with register set to false. Give it a try if that fails then set extension in contact, and contact in from to true. Then stop and start the gateway. You should see a status of 'noreg'.

Its now ready to use go to Dialplan -> Outbound Routes to select that Gateway and then you can send calls to it.

Mark Crane
  • 71
  • 2
0

You need to set "Register" to false, if the provider doesn't have a username & password.

I had to do this with a FXO gateway device. The gateway and pbx will work in peer mode (non-registered).

For the FXO gateway I needed to set the following settings:

  • Gateway: FXO_Gateway_1 (this is just a name)
  • Leave these field blank: Username, Password, From User, From Domain, Proxy, Realm
  • Register: False
  • Context: public
  • Profile: external
  • Leave Hostname blank. I made the mistake of setting this. It will not work.
  • Enabled: True
  • Click Advanced to set Outbound Proxy: <provider ip:port>
Neopallium
  • 1,419
  • 9
  • 18