The implemented badge is not shown clearly in the interface.why the badge is not clearly visible. tried zPsoition methods also.
The below image is shown to describe the issue.
Asked
Active
Viewed 78 times
0
-
How did you setup the interface using interface builder or using code. show us the relevant part regarding constraints, so that we can help – Sahil Manchanda Sep 17 '19 at 09:21
-
used coding @sa – Manish Kumar Sep 17 '19 at 09:22
-
2Then show us the code where you've setup the constraints – Sahil Manchanda Sep 17 '19 at 09:23
-
do you think that its a constraint issue@SahilManchanda – Manish Kumar Sep 17 '19 at 09:23
-
if you've used constraints then yes, if you are manually calculating positions and sizes then problem lies there – Sahil Manchanda Sep 17 '19 at 09:24
-
1Position issue? Or should it be visible above and outside the tile (in the black part)? If yes, it's a mask/clip to bound issue? – Larme Sep 17 '19 at 09:25
-
no i have not used constaints there yet.still half of the badge part is visible and half is not.@SahilManchanda – Manish Kumar Sep 17 '19 at 09:26
-
is there any way to remove the problem of this kind.@Larme – Manish Kumar Sep 17 '19 at 09:31
-
1Could you show what's your current goal? – Larme Sep 17 '19 at 09:32
-
my goal is to show the badge at the corner totally circular on which number can be seen@Larme – Manish Kumar Sep 17 '19 at 09:34
-
https://stackoverflow.com/questions/20449256/how-does-clipstobounds-work ? – Larme Sep 17 '19 at 09:43
-
thanks a lot ,mask issue was there @Larme – Manish Kumar Sep 18 '19 at 04:47
1 Answers
1
It's a mask/clip to bound issue.check your auto layout constraints of that view.
infinity_loop
- 156
- 1
- 11