I'm doing a simulation related to Mathworks Simulink Aircraft Electrical Power System Model. https://kr.mathworks.com/help/sps/ug/aircraft-electrical-power-generation-and-distribution.html Below is the normal model part for the Generator part. This model uses Simscape Electrical: Specialized Power System. enter image description here
I wanted to receive the current signal and change the current value using something like Simulink's Gain block. Before that test, I wanted to make sure that there was no error in the process of reading the SPS current signal to the Current Measurement block and then exporting it back to the Controlled Current Source. enter image description here
However, I found that the normal simulation results before putting in that subsystem and the signal conversion and export again after putting in the subsystem were different. enter image description here
I already know that the signal is usually read by the Controlled Current Source and sent to the Current Measurement block. But shouldn't it work the other way around? For your information, the Unit Delay block was put in to solve the algebraic loop, and I know that it has nothing to do with the simulation error result. I need your guys help.
I tried to several Simulation dealing with Gorund, I dont get why the block has the differences If current measurement Block just reads Current Sources as Timeseries Simulink Signal, and Controlled Current Source Exports the Exact Simulink signal that i put.
