0

I would like to connect two nets (or net classes) to one trace in altium. The issue I have two transistors and for my gate driver circuit, i need to connect the upper transistors source to a gate driver IC. This connection (blue) will carry a lot less current then the power connection (red) and thus should follow different design rules. My power connection should be a 5mm trace while the signal connection (blue) can be only 1mm wide. Is there a way to do it? Altium schematic editor view

I thought about creating a symbol which consists of two pins that I could place in between the nets. This symbol would ideally have no footprint but still be on the PCB or a piece of PCB trace as a footprint but I could not find a way to do that without violating manufacturer rules.

Skilluca
  • 1

1 Answers1

0

Ok found it after all! You can use "net ties", there is a good explanation here on how to do it properly.

Skilluca
  • 1