The Simon–Glatzel equation[1] is an empirical correlation describing the pressure dependence of the melting temperature of a solid. The pressure dependence of the melting temperature is small for small pressure changes because the volume change during fusion or melting is rather small. However, at very high pressures higher melting temperatures are generally observed as the liquid usually occupies a larger volume than the solid making melting more thermodynamically unfavorable at elevated pressure. If the liquid has a smaller volume than the solid (as for ice and liquid water) a higher pressure leads to a lower melting point.

The equation and its variations

and are normally the temperature and the pressure of the triple point, but the normal melting temperature at atmospheric pressure are also commonly used as reference point because the normal melting point is much more easily accessible. Typically is then set to 0.  and are component-specific parameters.

The Simon–Glatzel equation can be viewed as a combination of the Murnaghan equation of state and the Lindemann law,[2] and an alternative form was proposed by J. J. Gilvarry (1956):[3]

where is general at , is pressure derivative at , is Grüneisen ratio, and is the coefficient in Morse potential.

Example parameters

Methanol melting temperature versus pressure

For methanol the following parameters[4] can be obtained:

a188158kPa
a188.158MPa
b−15.15905
Tmin174.61K
Tmax228.45K
Pmax575000kPa
Pmax575.000MPa

The reference temperature has been Tref = 174.61 K and the reference pressure Pref has been set to 0 kPa.

Methanol is a component where the Simon–Glatzel works well in the given validity range.

Extensions and generalizations

The Simon–Glatzel equation is a monotonically increasing function. It can only describe the melting curves that rise indefinitely with increasing pressure. It may fail to describe the melting curves with a negative pressure dependence or local maximums. A damping term that asymptotically slopes down under pressure, (c is another component-specific parameter), is introduced by Vladimir V. Kechin to extend the Simon–Glatzel equation[5] so that all melting curves, rising, falling, and flattening, as well as curves with a maximum, can be described by a unified equation:

where is the Simon–Glatzel equation (rising) and is the damping term (falling or flattening).

The unified equation may be rewritten as:

This form predicts that all solids have a maximum melting temperature at a positive or (fictitious) negative pressure.

References

  1. Simon F. E., Glatzel G., Z. Anorg. (Allg.) Chem., 1929, 178, 309–312
  2. Anderson, Orson L. (1995). Equations of State of Solids for Geophysics and Ceramic Science. Oxford University Press. p. 281. ISBN 0-19-505606-X.
  3. Gilvarry, John James (1956). "Equation of the Fusion Curve". Physical Review. 102 (2): 325–331. Bibcode:1956PhRv..102..325G. doi:10.1103/PhysRev.102.325.
  4. Dortmund Data Bank
  5. Kechin V. V., J. Phys. Condens. Matter, 1995, 7, 531–535
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.