I am having some problems reading analog values from my Arduino Mega using pyfirmata. I use Arduino Mega with a Mega Sensor Shield. I would like to read analog values from a HW-201 IR sensor (pin A5). I have uploaded the Standard firmata sketch on Arduino IDE, and I am running the following code using Anaconda Spyder:
import serial
import serial.tools.list_ports
from pyfirmata import ArduinoMega, util
from time import sleep
def readArduinoPort():
COM = []
ports = list(serial.tools.list_ports.comports())
for p in ports:
if "Arduino" in p.description:
COM.append(str(p.device))
return COM
COM = readArduinoPort()
board = ArduinoMega(COM[0])
pin = board.get_pin('a:5:i')
it = util.Iterator(board)
it.start()
try:
while True:
print(pin.read())
sleep(0.1)
except KeyboardInterrupt:
pass
Now, this code runs just fine the first time I use it, generating numbers close to 1 when the sensor is detecting proximity and numbers close to 0 when not detecting anything.
However, whenever I try to run the Iterator a second time (without restarting the kernel), the code generates seemingly random numbers (almost like the pin was floating, like nothing was connected to it).
Any idea why this is happening? Is this a normal behavior? Thank you!
I already checked these questions that do not entirely address my issue:
I have the same result by not having anything pinned to pin A5 of the Arduino Mega.
I wasn't sure, but I tried adding:
board.analog[5].enable_reporting()
before the iterator and then:
board.analog[5].disable_reporting()
but nothing changed.
